The Sentar II has long been noted as the “workhorse” of irrigation controllers. It offers advanced control features for a fraction of the cost of similar models. Designed with the irrigation manager in mind, the Sentar II protects landscapes by offering; rain sensing, flow sensing, and cycle and soak scheduling on any of 4 fully independent programs.

Built-in remote jack

For use with Irritrol Pro Max™ remotes and optional permanent mount receiver

Commercial-grade,lockable steel & stainless steel cabinet and pedestals

For vandal resistance and longer service life

Cycle and soak

To eliminate runoff and conserve water

Four independent programs

With five selectable start times for a total of 20 possible irrigation cycles per day

Seven day week or skip-by-day scheduling

To match water restrictions and varied plant water requirements

Non-volatile memory

Retains all program data for reliable operation

Programmable overlap protection

Allows programs to run one after the other (stack mode) or at the same time (no stack mode)

CUL Listed
FCC
Input Power Required
105-130V ac, 50/60 Hz, 0.5 amp maximum, 0.1 amp idle
Output Power
24V ac 1.5 amps maximum total output (36VA) 1 amp per station or master valve
Programmable Time Delay Between Stations
From 1 to 256 seconds - permits slow-closing valves to fully close
Programmable Alarm
Enables or disables an audible alert in the event of a field wire fault
Security Lock Out
Allows entry of a 1-4 digit number as a security code to prevent access by unauthorized personnel
UL Listed
PMRKIT: Permanent mount receiver kit for use with Pro Max™ remote
RMPED-1: Outdoor pedestal

WHERE TO BUY

LOCATE A DISTRIBUTOR